To fix a wobbly ceiling fan make sure it s mounted on a fan rated electrical box check the box a properly mounted fan will be attached to a fan rated box mounted either on a 2 4 with lag screws or to an adjustable fan brace.
Ceiling fan ball joint wobble.
The ball joint should be properly engaged to your support bracket.
Ceiling fan generally wobbles because of these two reasons.
A wobbling ceiling fan is loud unsightly and dangerous if not dealt with properly.
Ceiling fan wobble is caused by imbalances in the fan blades or blade holders misalignment of blades excess dust accumulation or just loose ceiling fan mounting.
In addition determine that the outlet box is firmly attached to the ceiling joists.
It s kind of surprising if they don t wobble at least a little bit.
It doesn t always work though.
If the pin is damaged or bent you re going to get a wobble.
If a ceiling fan balancing kit does not solve your wobbly woes verify the outlet box used to install the ceiling fan is rated for fans only and is capable of withstanding the fan s weight.
But sometimes they wobble a lot.
Please read the comments and see that this does work for some people.
If your ceiling fan wobbles it s usually due to one of two reasons.
Bolt and nut at pulley area not fully tighten.
Well if you think about it a ceiling fan is a spinning motor with blades attached like a propeller that hangs from a rod that s mounted to your ceiling.
As with all machines that have moving parts ceiling fans will suffer from wear and begin to get loose.
All you need is a screwdriver a yardstick and some light weights such as a cheap blade balancing kit or coins and clear tape to get your ceiling fan running smoothly.
It may be due to a low quality ceiling fan but it could also be due to a balancing issue.
Either it s not securely attached to the ceiling or the blades are unbalanced.
Restore your fan to its smooth running days of old before you wear down the moving parts.
The longer the fan s blades the more the air circulates and the cooler the room is.
Ball joint not properly inserted into guide.
Tighten the bolt and nut completely.
This is held in place with a cotter pin that runs through the rod and into the mount.
A slight wobble of about 1 8 while running on high is normal.
You may contact a licensed electrician to review the installation.
But need not to worry as the problems are minor and can be fixed.
Insert the ball joint at the guide plate according to manual.
Yes i know the switch is summer winter but this works to.
